Quote:
Originally Posted by duke knooby
All the guides bar one say to drill out the crossmember, one says just to hammer the inserts in
|
A very detailed American site is listing the factory pressed holes as 390 thou, and the inserts as 431 thou...
Assuming Germans weren't working in thousandths of inches back then, 9.9mm hole, which I'm gonna assume was a 10mm hole when it left the factory over 20 years ago, before getting filled with surface corrosion or similar crud. And a 10.95mm insert...
11mm insert isn't gonna fit nicely in a 10mm hole
gonna have to drill it